Peumatic Grouting pump is designed for strain and filling grouting of cement and bentonite slurries. It is primarily used for injecting (grouting) bar anchors and the drill holes so as to reinforce the loose rock mass. The maximum grain dimension can not exceed zero.2 mm.
Grouting pump operation and upkeep is straightforward, protected and dependable. This pump is used in mines operating under tough conditions because it is reliable and explosion-proof.
Basic Pneumatic Grouting pump embrace: An air inlet, the pneumatic cylinder, mounting base frame and stand, stress gauge, pumping cylinder, outlet with quick launch coupling and wheels.
How it works
Pneumatic pressure in the air cylinder exerts a high pressure on the grout mixture which finally ends up in ejection of grout with a excessive pressure and velocity. The valves of the air cylinder within the pump function mechanically to actuate the cylinder. The pneumatic cylinder then moves the plunger up and down to finish the pumping cycle.
Pneumatic grout pump could be driven even with out Electrical power supply in remote areas through the use of engine driven compressor.
Applications
The pump is majorly used in construction and mining industry for injecting material into extensive and medium dimension gap in beams, columns ,basement partitions and flooring, raise shaft concrete wall fill-up etc. In mining industry it’s used to fill up cement resolution the place there’s a hole exists between construction and rock and for soil stabilization.
Detachable design tends to simple upkeep and transportation. Challenging works like Grouting in Bridges.
READ: How hydraulic submersible pumps work
This pump is broadly used in tunnels, coal mine, bridges and dams, building foundation, and different underground initiatives, and inflammable, explosive websites and different bad environment.
It has application in chemical business also to pump out chemical slurries.
The pump is electrical energy free so, can be utilized at any web site condition whether it is rural or city.
Mining Pneumatic Grouting pump has a bigger discharge slurry adjustment vary. Generally the final amount of the grouting volume is eight or10 times of the quantity to start with. And the ultimate grouting amount proves that filling is compacted.
Simply put; Pneumatic high-pressure grouting pump is specially designed for high-pressure grouting. And it adopts full hydraulic drive, it’s pressure and move may be adjusted based on the requirements of grouting,(The circulate of grouting pump is 0-100L/min, pressure of discharge is 0-10MPa).apart from, This Pneumatic high-pressure grouting pump can be used for grouting single or double fluid.
High-pressure grouting pump is especially used for highways, railways, water and electricity, construction, mining etc. ground/underground construction.
Benefits
Mining Pneumatic Grouting pump has some great benefits of low energy consumption, small vibration, low noise, small measurement, excessive efficiency, dependable efficiency, stress and move management, lengthy life and so on. Common mine grouting pump has pneumatic injection pump, dual fluid injection pump, extrusion injection pump and piston injection pump.
เครื่องมือวัดpressure is also Light weight and with a wheelie design it may be carried easily. It is designed for easy operation and low upkeep. Last however not least its spare parts are easily available.
Share